How to Remove Limescale from the Toilet
“Tackles limescale and smells out of this world. Power Stain Destroyer is cleaning reinvented!”
-Scrubby
Limescale is as icky and nasty as the name sounds. And deposits can build up wherever there’s hard water.
When it does, Scrubbing Bubbles® Power Stain Destroyer Toilet Bowl Cleaner gives limescale build up a nasty take down. The green liquid turns blue as it drops the boom.
Then once it’s gone, you can keep it gone with Scrubbing Bubbles® Fresh Gel Toilet Cleaning System. Just stamp a gel disc under the rim and get a fresh clean with every flush. That way, limescale doesn’t get comfortable enough to stick around.
Hard water or not, limescale doesn’t deserve a sporting chance. Not on Scubby’s watch!
How-To Steps
HOW TO REMOVE LIMESCALE
Lift the toilet seat.
To remove the cap, squeeze the two textured side surfaces and unscrew completely.
Tip the bottle to fill the neck. Direct liquid under the rim and squeeze evenly around the bowl.
To remove limescale and rust coat the bowl and allow to sit for 15 minutes. In case of very tough limescale and/or rust re-apply and leave overnight.
Brush the entire bowl and flush.
Replace cap and close tightly until an audible click is heard. .
For stubborn stains, allow product to sit for more than 15 minutes.
KEEP LIMESCALE AWAY
Apply Scrubbing Bubbles® Fresh Gel Toilet Cleaning Stamp to a clean toilet.
SNAP: Slide the two pieces together so that the button on the GEL TUBE snaps into the first hole on the blue HANDLE.
PLACE: Remove cap and position end of GEL TUBE near the rim on inside of bowl.
PUSH: Press and hold button down while pushing unit towards the bowl. When button clicks into the next hole, pull unit back to leave a gel stamp.
CAP: Replace cap securely and store.
REFILL: After dispensing the last gel stamp, remove GEL TUBE from APPLICATOR. Keep APPLICATOR for refill.
Retain outer packaging for full use and safety instructions.